Can I Use A 4500 Wattage Element In My Water Heater?

What is the wattage of a 40 gallon water heater?

4500 wattsYour average residential 30 or 40 gallon water heater is 4500 watts and usually goes on a 30 A breaker..

Does water heater use a lot of electricity?

How Much Electricity Does a Hot Water Heater Use? … Typically, a hot water heater that uses a tank will run for three to five hours per day. So, a 4,000-watt heater used for three hours a day at $. 10 per kWh will cost $1.20 per day, about $36.50 per month, or $438 per year.

How many watts does a hot water tank use?

Water heaters running on 120-volt power have a long recovery time, which is impractical for most households; 120-volt elements consume 1125 watts, while residential 240-volt heaters use 4,500 watts.

How many amps is 4500 watts?

18.75 ampsIn an electric circuit of 240 volts, 4500 watts is equivalent to 18.75 amps.

Can I replace a 4500 Watt water heater with a 5500 Watt?

Can I replace 4500 watt elements with 5500 watt? You can definitely replace 4500 watt with 5500 watt and get 4-7 gallons more hot water from a tank.

Can I replace a 3500 Watt water heater with a 4500 Watt?

When selecting element, buy same wattage or less wattage… keep volts the same. It is ok to install higher watt up to 5500 on 4500 watt heater if breaker is 30 amp and wire is 10 gauge. It is ok to install lower watt: replace 4500 with 3500 as long as voltage is same.

How many watt generator do I need to run a hot water heater?

5,000 watt generator generatorA 5,000 watt generator generator is capable of running a electric water heater, but caution should be taken not to exceed the generator’s total 5,000 wattage rating. A electric water heater needs 4,500 watts to start the appliance and 3,500 watts to continue powering the heater.

Can I replace a 3800 Watt water heater with a 4500 Watt?

Consequently, can I replace a 3800 Watt water heater with a 4500 Watt? You can buy 3800 watt elements to replace the 4500 watt units. This is commonly done when the electric is NOT 10 gauge wire with 30 amp breaker. If it is 12 gauge and 20 amp you are limited to 3800 watt elements.

What resistance should a 4500 watt water heater element have?

A 3,500-watt element should register 16 ohms, a 4,500-watt element should register between 12 and 13 ohms, and a 5,500-watt element should register between 10 and 11 ohms.